A point of sail is a sailing craft's direction of travel under sail in relation to the true wind direction over the surface.
The principal points of sail roughly correspond to 45° segments of a circle, starting with 0° directly into the wind. For many sailing craft 45° on either side of the wind is a "no-go" zone, where a sail is unable to mobilize power from the wind. Sailing on a course as close to the wind as possible--approximately 45°--is termed "close-hauled". At 90° off the wind, a craft is on a "beam reach". At 135° off the wind, a craft is on a "broad reach". At 180° off the wind (sailing in the same direction as the wind), a craft is "running downwind".
In points of sail that range from close-hauled to a broad reach, sails act substantially like a wing, with lift predominantly propelling the craft. In points of sail from a broad reach to down wind, sails act substantially like a parachute, with drag predominantly propelling the craft. For craft with little forward resistance, like ice boats and land yachts, this transition occurs further off the wind than for sailboats and sailing ships. In the no-go zone, sails are unable to generate motive power from the wind.
Wind direction for points of sail always refers to the true wind--the wind felt by a stationary observer. The apparent wind--the wind felt by an observer on a moving sailing craft--determines the motive power for sailing craft.
Video Point of sail
No-go zone
Sailing craft, such as sailboats and ice boats, cannot sail directly into the wind, nor on a course that is too close to the direction from which the wind is blowing. The range of directions into which a sailing craft cannot sail is called the "no-go" zone. In the no-go zone the craft's sails cease producing enough drive to maintain way or forward momentum; therefore, the sailing craft slows down towards a stop and steering becomes progressively less effective at controlling the direction of travel. The span of the no-go zone varies among sailing craft, depending on the design of the sailing craft, its rig, and its sails, as well as on the wind strength and, for boats, the sea state. Depending on the sailing craft and the conditions, the span of the no-go zone may be from 30 to 50 degrees either side of the wind, or a 60- to 100-degree area centered on the wind direction.
In irons
A sailing craft is said to be "in irons" if it is stopped with its sails unable to generate power in the no-go zone. If the craft tacks too slowly, or otherwise loses forward motion while heading into the wind, the craft will coast to a stop. This is also known as being "taken aback," especially on a square-rigged vessel whose sails can be blown back against the masts, while tacking.
Maps Point of sail
Close-hauled
A sailing craft is said to be sailing close-hauled (also called beating or working to windward) when its sails are trimmed in tightly, are acting substantially like a wing, and the craft's course is as close to the wind as allows the sail(s) to generate maximum lift. This point of sail lets the sailing craft travel diagonally to the wind direction, or 'upwind'.
The smaller the angle between the direction of the true wind and the course of the sailing craft, the higher the craft is said to point. A craft that can point higher (when it is as close-hauled as possible) is said to be more weatherly.
Reaching
When the wind is coming from the side of the sailing craft, this is called reaching.
A "beam reach" is when the true wind is at a right angle to the sailing craft.
A "close reach" is a course closer to the true wind than a beam reach but below close-hauled; i.e., any angle between a beam reach and close-hauled. The sails are trimmed in, but not as tight as for a close-hauled course.
A "broad reach" is a course further away from the true wind than a beam reach, but above a run. In a broad reach, the wind is coming from behind the sailing craft at an angle. This represents a range of wind angles between beam reach and running downwind. On a sailboat (but not an iceboat) the sails are eased out away from the sailing craft, but not as much as on a run or dead run (downwind run). This is the furthest point of sail, until the sails cease acting substantially like a wing.
Running downwind
On this point of sail (also called running before the wind), the true wind is coming from directly behind the sailing craft. In this mode, the sails act in a manner substantially like a parachute.
When running, the mainsail is eased out as far as it will go. The jib will collapse because the mainsail blocks its wind, and must either be lowered and replaced by a spinnaker, or set instead on the windward side of the sailing craft. Running with the jib to windward is known as 'gull wing', 'goose wing', 'butterflying' or 'wing and wing'. A genoa gull-wings well, especially if stabilized by a whisker pole, which is similar to but lighter than a spinnaker pole.
Effect on sailing craft
True wind (VT) combines with the sailing craft's velocity (VB) to be the apparent wind velocity (VA); the air velocity experienced by instrumentation or crew on a moving sailing craft. Apparent wind velocity provides the motive power for the sails on any given point of sail. It varies from being the true wind velocity of a stopped craft in irons in the no-go zone to being faster than the true wind speed as the sailing craft's velocity adds to the true windspeed on a reach, to diminishing towards zero, as a sailing craft sails dead downwind.
- Effect of apparent wind on sailing craft at three points of sail
Sailing craft A is close-hauled. Sailing craft B is on a beam reach. Sailing craft C is on a broad reach.
Boat velocity (in black) generates an equal and opposite apparent wind component (not shown), which adds to the true wind to become apparent wind.
The speed of sailboats through the water is limited by the resistance that results from hull drag in the water. Ice boats typically have the least resistance to forward motion of any sailing craft; consequently, a sailboat experiences a wider range of apparent wind angles than does an ice boat, whose speed is typically great enough to have the apparent wind coming from a few degrees to one side of its course, necessitating sailing with the sail sheeted in for most points of sail. On conventional sail boats, the sails are set to create lift for those points of sail where it's possible to align the leading edge of the sail with the apparent wind.
For a sailboat, point of sail significantly affects the lateral force to which the boat is subjected. The higher the boat points into the wind, the stronger the lateral force, which results in both increased leeway and heeling. Leeway, the effect of the boat moving sideways through the water, can be counteracted by a keel or other underwater foils, including daggerboard, centerboard, skeg and rudder. Lateral force also induces heeling in a sailboat, which is resisted by the shape and configuration of the hull (or hulls, in the case of catamarans) and the weight of ballast, and can be further resisted by the weight of the crew. As the boat points off the wind, lateral force and the forces required to resist it become reduced. On ice boats, lateral forces are countered by the lateral resistance of the blades on ice and their distance apart, which generally prevents heeling.
See also
- Broach (sailing)
- Glossary of nautical terms
- Sailing
References
Bibliography
- Rousmaniere, John, The Annapolis Book of Seamanship, Simon & Schuster, 1999
- Chapman Book of Piloting (various contributors), Hearst Corporation, 1999
- Herreshoff, Halsey (consulting editor), The Sailor's Handbook, Little Brown and Company, 1983
- Seidman, David, The Complete Sailor, International Marine, 1995
- Jobson, Gary, Sailing Fundamentals, Simon & Schuster, 1987
Source of article : Wikipedia
0 Comments